Regulation

Building an exhibition or conference centre in Saudi Arabia: what SCEGA's guide asks for

The Saudi Conventions & Exhibitions General Authority has published a guide to building and operating exhibition and conference centres. Its size classes, licensing steps and operating requirements, and what it leaves to other codes.

Dynamics team Editorial desk

4 min read Regulation

Building an exhibition or conference centre in Saudi Arabia: what SCEGA's guide asks for
In this article
  1. Six kinds of venue
  2. Minimum sizes
  3. Site and parking
  4. Licensing the build
  5. Inside the building
  6. Operating
  7. What the guide does not say
  8. Frequently asked questions
  9. Who issued the guidelines for building and operating exhibition and convention centers?
  10. What is the minimum size for a small exhibition and conference centre?
  11. Does SCEGA's approval come before the municipal permit?
  12. Is the guide binding?
  13. Sources

The Saudi Conventions & Exhibitions General Authority (SCEGA) publishes its "Guidelines for Building and Operating Exhibition and Convention Centers" on the reports page of its website, 51 pages in the Arabic edition. It sets out what government bodies require of a new centre and what it should be built and equipped to, based on benchmarking and field visits by the authority. The figures below are from the version on SCEGA's website as we read it on 10 November 2026.

Six kinds of venue

The guide sorts business-event venues into six categories:

Category What it is, per the guide
Exhibition and conference centre Standalone: exhibition space, auditorium, side halls
Exhibition centre Standalone: exhibition space, meeting rooms
Conference centre Standalone: an equipped auditorium, side halls
Event halls Standalone hall for many kinds of event
Hotel halls Event space inside a hotel
Multi-use facilities Space inside a government or private building

The fifth is not a footnote: in SCEGA's open data for Q1 2024, roughly nine in ten licensed private-sector business events took place in hotels (our reading of that data).

Minimum sizes

Table 1 of the guide sets a minimum exhibition area and auditorium size for each class, and where each class applies. For exhibition and conference centres:

Class Exhibition area (m²) Auditorium seats (min) Applies in
Mega over 250,000 5,000 Riyadh
Large 101,000 – 250,000 2,500 Riyadh, Jeddah, Dammam
Medium 21,000 – 100,000 1,500 All regions
Small 3,000 – 20,000 1,000 Mid-size and small cities and governorates

Exhibition-only centres use the same area bands without an auditorium. Conference centres are smaller: 11,000 m² and 5,000 seats for the mega class in Riyadh, Jeddah and Dammam, and 3,000 m² and 2,500 seats for the large class, which extends to Asir, Jazan, NEOM, AlUla and Qassim. A dual or multi-use centre has a single floor: 500 m² and 500 seats. The guide counts capacity at 2 m² per person.

Site and parking

  • Commercial land outside residential areas, zoned for exhibitions and conferences, with separate goods entrances.
  • On main roads, within 4 km of airports, accommodation, shopping centres and parks.
  • Away from polluting factories, flood channels, high-voltage towers, petrol stations and cemeteries.
  • One parking space per 10 m² of exhibition area at exhibition centres (with or without a conference wing), one per 5 people at conference centres, and at least one EV charger. Basements are for parking only.

Licensing the build

  1. SCEGA endorsement: an online request to the authority, with preliminary plans approved by a consulting office, a feasibility study, and a traffic study from an accredited office covering trucks, visitors and exhibitors.
  2. Building permit: an application to the relevant municipality for the type of centre, with SCEGA's endorsement attached.
  3. Design and construction: full drawings and supervision by a consulting office qualified with the Ministry of Municipalities and Housing, contractors qualified with the Saudi Contractors Authority, and compliance with the Saudi Building Code and Civil Defense requirements.

Inside the building

Item What the guide asks for
Exhibition hall height 8 – 12 m depending on size, 18 m at most
Ceiling and floor Ceiling rigging points every 8 m²; floor loads up to 3 tonnes per m² in parts of the hall
Meeting rooms One per 1,000 m² of exhibition or conference area
Foyer At least 35% of the largest hall
Truck holding 20 trucks per 10,000 m² of exhibition area
Toilets 1 per 100 m² in exhibition halls, 1 per 50 m² at conference centres
Prayer rooms Room for 10 – 15% of daily visitors

Operating

To open, the guide requires a commercial register and a municipal licence for activity 823006, "operating exhibition and conference centres and facilities"; a Ministry of Investment licence for foreign companies; Civil Defense approvals; and registration on SCEGA's e-portal. Beyond that it recommends quality markers: CMP or CEM certificates for planning staff, ISO 9001, 14001, 22301 and 45001, and free internet averaging 100 Mbps per 200 people. It also advises against incense and air fresheners in enclosed areas while visitors are present.

What the guide does not say

  • It is not a regulation. It calls itself guidance; its third phase is work on an implementing regulation. What binds today is what it points to: the Saudi Building Code, Civil Defense and the Ministry of Municipalities and Housing.
  • No fees, no timelines. Neither the endorsement fee nor how long a decision takes.
  • The engineering chapters are references. Structural, electrical and mechanical guidance is one line each: follow the building code.
  • No demand figures. It asks for a feasibility study but gives no demand data for any city, and does not define "mid-size and small cities".

Thresholds can change between versions; check the guide on SCEGA's website before relying on them. This article summarises the guide; it is not a substitute for the text or for legal or engineering advice.

Frequently asked questions

Who issued the guidelines for building and operating exhibition and convention centers?

The Saudi Conventions & Exhibitions General Authority (SCEGA), which publishes it in Arabic and English on the reports page of its website.

What is the minimum size for a small exhibition and conference centre?

3,000 m² of exhibition area and a 1,000-seat auditorium (Table 1 of the guide), in mid-size and small cities and governorates.

Does SCEGA's approval come before the municipal permit?

Yes, per the guide: the endorsement request goes to SCEGA online first, and the endorsement is attached to the municipal building application.

Is the guide binding?

It is guidance. The binding requirements are in the codes it refers to, and per the guide SCEGA is working on an implementing regulation.

Sources

Share this insight

Written by

Dynamics team

Editorial desk — the team that reviews listings and keeps the directory's data current.

All insights
Ask AI

Ask about any place or person

Ask your question about a Saudi place or person